ATTN D-Link users

Post Reply
Guest

ATTN D-Link users

Post by Guest » Tue Feb 24, 2004 7:06 pm

Im not sure if this will help a lot of you our or not with thse, but i just discovered out of months of trying to get mech4 to work that in a section called Special Aps or Special Applications in the firm ware, there is a preset for MSN Gaming Zone, which will set up the right inbounds and outbounds (or whatever, im not done with my Cisco cert stuff yet :D ). but anyway, it will connect just fine now, and you dont need the Dx program either. My router is a D-Link Dl-704 btw

peace

wsware
PuffinSoft
PuffinSoft
Posts: 717
Joined: Wed May 29, 2002 6:25 pm

Post by wsware » Wed Feb 25, 2004 6:26 am

Very true. Most should need DXport only if they have more than one PC behind the router.

Guest

Post by Guest » Thu Aug 19, 2004 5:07 am

I have a D-Link something and I have 3 computers behind my router do I need that software?
:?:

wsware
PuffinSoft
PuffinSoft
Posts: 717
Joined: Wed May 29, 2002 6:25 pm

Post by wsware » Fri Aug 20, 2004 7:54 am

You will have to use DXport so break up the directX ports and forward that range of ports to each PC. Look at some of the instrctions and the main page for more info.

Post Reply